So here is my new one. First I carve a piece of wax, for what I want. Then it will be cast.
front- http://imgur.com/BWzWu
Back - http://i.imgur.com/lUaM2.jpg
front- http://imgur.com/BWzWu
Back - http://i.imgur.com/lUaM2.jpg
-
BOTL UPCOMING MAINTENANCE
Hi Everyone, as mentioned in my introduction post, BOTL needs quite a bit of updating, patching and whatever else I might come across. Over the next few weekends BOTL may be unreachable on occasion as I do migrations or updates, etc. Just be patient - we'll be back! I'll generally try to keep these maintenances until later in the evenings.
There was quiet an interest in how I made my first custom Xikar cutter.
- Thread starter kdubb666
- Start date
That is going to look great. I have always wanted to try my hand at wax carving.
Cigary43
Just Another Ashhole
I had never considered even doing something like this and after seeing the photos it is limitless as to what can be done or shown on those cutters. Great idea and this could really be something you could promote privately and do for others....very cool. I bet others after seeing this will have some of their own ideas as to what they'd like on their own cutter. How about a U Tube as to how you do or did this...I'm very interested in this...thx.
http://imgur.com/OUFV2 It is now cast. I have to clean up, set some stones, and finish. Thank you all for your kind words.
This one is for me. The first one I made was for my dear friend Tank, to match the band of his newly launched cigar.
opeyes:
danthebugman
BoM Nov '10
That is sweet! Nice work...very nice work :thumbsup:.
Dan
Dan
Finished, for now. Front http://imgur.com/lIGNi
Back http://imgur.com/sGR6B
Thank you all for your approval. I cant wait to make another.
Back http://imgur.com/sGR6B
Thank you all for your approval. I cant wait to make another.
Last edited: