Started with a PA-10 stripped lower. Putting these together is just like putting together an AR15 lower. Beware, though, not all the parts are the same as an AR15! That's a Magpul MOE stock on a rifle length receiver extension and buffer.

Charging handle from e-bay, bolt carrier group from AIM, got the DPMS stripped upper from Midway on clearance.

20" barrel from Black Hole Weaponry. Rifle length gas system.
Midwest industries 15" hand guard.

Quick test fit. Everything is good to go.

Put that guy in an upper vice and tighten to 60 lbs/sq ft. Notches line up nice for the gas tube. The vice block was made for AR15's, not LR308 uppers. I was able to use it by putting the upper in there cock-eyed.

The gas block was a tight fit. A little Frog Lube solves that problem lickety-split.

Handguard and cheap Chinese muzzle brake on.

Ready to go!

Good fit!


Charging handle from e-bay, bolt carrier group from AIM, got the DPMS stripped upper from Midway on clearance.

20" barrel from Black Hole Weaponry. Rifle length gas system.
Midwest industries 15" hand guard.

Quick test fit. Everything is good to go.

Put that guy in an upper vice and tighten to 60 lbs/sq ft. Notches line up nice for the gas tube. The vice block was made for AR15's, not LR308 uppers. I was able to use it by putting the upper in there cock-eyed.

The gas block was a tight fit. A little Frog Lube solves that problem lickety-split.

Handguard and cheap Chinese muzzle brake on.

Ready to go!

Good fit!

Last edited: