p.m. sent
For anyone looking for this in the future:
Defining the setpoints for the Habitat Monitor
-The setpoints are displayed and changed sequentially, in the following order:
-low temperature
-high temperature
-low humidity
-high humidity
To access the setpoints, press and hold the front panel button for approximately six seconds, until the dispalys change, then release the button.
1. The LOW temperature setpoint is displayed in the upper display, the word "LO" is displayed in the lower display.
TO CHANGE THE SETPOINT, simply press the front panel button. The number will increase by one each time the buttons is pressed. The numbers will increase until 99, then begin again at zero ('00). Alternately, press and hold the front panel button until the desired number is displayed. the 'counting' will go faster, the longer the button is held.
Once the desired setpoint is displayed, release the button and wait for ten seconds until you hear a beep. The new value will be stored and the HABITAT MONITOR will automatically advance to the next setpoint.
2. The next setpoint is the HIGH Temp setpoint. The setpoint is displayed in the upper display, the word "HI" is displayed in the lower display. Follow the instructions above to change the setpoint.
3. The next setpoint is the LOW HUMIDITY setpoint. The word "LO" is displayed in the upper display and the low humidity setpoint is lisplayed in the lower display. Follow the instructions above to change the setpoint.
4. The next setpoint is the HIGH HUMIDITY setpoint. The word "HI" is displayed in the upper display and the high humidity setpoint is displayed in the lower display. Follow the instruction above to change the setpoint.
After the High Humidity setpoint has been displayed/adjusted, the displays will clear momentairly, then the temperature and humidity readings will be displayed indicating that the Habitat Monitor has resumed normal operations.